4.18.1. Características de la red configurando kernel
Many features of the kernel can be modified while running by echoing something into the
/proc file system or by using
sysctl. By entering
/sbin/sysctl -A you can see what you can configure and what the options are, and it can be modified running
/sbin/sysctl -w variable=value
(see
sysctl(8)). Only in rare cases do you need to edit something here, but you can increase security that way as well. For example:
net/ipv4/icmp_echo_ignore_broadcasts = 1
This is a Windows emulator because it acts like Windows on broadcast ping if this option is set to 1. That is, ICMP echo requests sent to the broadcast address will be ignored. Otherwise, it does nothing.
If you want to prevent you system from answering ICMP echo requests, just enable this configuration option:
net/ipv4/icmp_echo_ignore_all = 0
Los paquetes con direcciones imposibles (debido a las rutas incorectas) sobre el registro que obtuvo su red.
/proc/sys/net/ipv4/conf/all/log_martians = 1
For more information on what things can be done with
/proc/sys/net/ipv4/* read
/usr/src/linux/Documentation/filesystems/proc.txt. All the options are described thoroughly under
/usr/src/linux/Documentation/networking/ip-sysctl.txt.
4.18.2. Configuring syncookies
This option is a double-edged sword. On the one hand it protects your system against syn packet flooding; on the other hand it violates defined standards (RFCs).
net/ipv4/tcp_syncookies = 1
If you want to change this option each time the kernel is working you need to change it in
/etc/network/options by setting
syncookies=yes. This will take effect when ever
/etc/init.d/networking is run (which is typically done at boot time) while the following will have a one-time effect until the reboot:
echo 1 > /proc/sys/net/ipv4/tcp_syncookies
This option will only be available if the kernel is compiled with the
CONFIG_SYNCOOKIES. All Debian kernels are compiled with this option builtin but you can verify it running:
$ sysctl -A |grep syncookies
net/ipv4/tcp_syncookies = 1
4.18.3. Securing the network on boot-time
When setting configuration options for the kernel networking you need configure it so that it's loaded every time the system is restarted. The following example enables many of the previous options as well as other useful options.
There are actually two ways to configure your network at boot time. You can configure /etc/sysctl.conf (see: sysctl.conf(5)) or introduce a script that is called when the interface is enabled. The first option will be applied to all interfaces, whileas the second option allows you to configure this on a per-interface basis.
An example of a
/etc/sysctl.conf configuration that will secure some network options at the kernel level is shown below. Notice the comment in it,
/etc/network/options might override some values if they contradict those in this file when the
/etc/init.d/networking is run (which is later than
procps on the startup sequence).
#
# /etc/sysctl.conf - Configuration file for setting system variables
# See sysctl.conf (5) for information. Also see the files under
# Documentation/sysctl/, Documentation/filesystems/proc.txt, and
# Documentation/networking/ip-sysctl.txt in the kernel sources
# (/usr/src/kernel-$version if you have a kernel-package installed)
# for more information of the values that can be defined here.
#
# Be warned that /etc/init.d/procps is executed to set the following
# variables. However, after that, /etc/init.d/networking sets some
# network options with builtin values. These values may be overridden
# using /etc/network/options.
#
#kernel.domainname = example.com
# Additional settings - adapted from the script contributed
# by Dariusz Puchala (see below)
# Ignore ICMP broadcasts
net/ipv4/icmp_echo_ignore_broadcasts = 1
#
# Ignore bogus ICMP errors
net/ipv4/icmp_ignore_bogus_error_responses = 1
#
# Do not accept ICMP redirects (prevent MITM attacks)
net/ipv4/conf/all/accept_redirects = 0
# _or_
# Accept ICMP redirects only for gateways listed in our default
# gateway list (enabled by default)
# net/ipv4/conf/all/secure_redirects = 1
#
# Do not send ICMP redirects (we are not a router)
net/ipv4/conf/all/send_redirects = 0
#
# Do not forward IP packets (we are not a router)
# Note: Make sure that /etc/network/options has 'ip_forward=no'
net/ipv4/conf/all/forwarding = 0
#
# Enable TCP Syn Cookies
# Note: Make sure that /etc/network/options has 'syncookies=yes'
net/ipv4/tcp_syncookies = 1
#
# Log Martian Packets
net/ipv4/conf/all/log_martians = 1
#
# Turn on Source Address Verification in all interfaces to
# prevent some spoofing attacks
# Note: Make sure that /etc/network/options has 'spoofprotect=yes'
net/ipv4/conf/all/rp_filter = 1
#
# Do not accept IP source route packets (we are not a router)
net/ipv4/conf/all/accept_source_route = 0
To use the script you need to first create the script, for example, in
/etc/network/interface-secure (the name is given as an example) and call it from
/etc/network/interfaces like this:
auto eth0
iface eth0 inet static
address xxx.xxx.xxx.xxx
netmask 255.255.255.xxx
broadcast xxx.xxx.xxx.xxx
gateway xxx.xxx.xxx.xxx
pre-up /etc/network/interface-secure
In this example, before the interface eth0 is enabled the script will be called to secure all network interfaces as shown below.
#!/bin/sh -e
# Script-name: /etc/network/interface-secure
#
# Modifies some default behavior in order to secure against
# some TCP/IP spoofing & attacks for all interfaces.
#
# Contributed by Dariusz Puchalak.
#
echo 1 > /proc/sys/net/ipv4/icmp_echo_ignore_broadcasts
# Broadcast echo protection enabled.
echo 0 > /proc/sys/net/ipv4/conf/all/forwarding
# IP forwarding disabled.
echo 1 > /proc/sys/net/ipv4/tcp_syncookies # TCP syn cookies protection enabled.
echo 1 >/proc/sys/net/ipv4/conf/all/log_martians # Log strange packets.
# (this includes spoofed packets, source routed packets, redirect packets)
# but be careful with this on heavy loaded web servers.
echo 1 > /proc/sys/net/ipv4/icmp_ignore_bogus_error_responses
# Bad error message protection enabled.
# IP spoofing protection.
echo 1 > /proc/sys/net/ipv4/conf/all/rp_filter
# Disable ICMP redirect acceptance.
echo 0 > /proc/sys/net/ipv4/conf/all/accept_redirects
echo 0 > /proc/sys/net/ipv4/conf/all/send_redirects
# Disable source routed packets.
echo 0 > /proc/sys/net/ipv4/conf/all/accept_source_route
exit 0
Notice that you can actually have per-interface scripts that will enable different network options for different interfaces (if you have more than one), just change the pre-up line to:
pre-up /etc/network/interface-secure $IFACE
And use a script which will only apply changes to a specific interface, not to all of the interfaces available. Notice that some networking options can only be enabled globally, however. A sample script is this one:
#!/bin/sh -e
# Script-name: /etc/network/interface-secure
#
# Modifies some default behavior in order to secure against
# some TCP/IP spoofing & attacks for a given interface.
#
# Contributed by Dariusz Puchalak.
#
IFACE=$1
if [ -z "$IFACE" ] ; then
echo "$0: Must give an interface name as argument!"
echo "Usage: $0 <interface>"
exit 1
fi
if [ ! -e /proc/sys/net/ipv4/conf/$IFACE/ ]; then
echo "$0: Interface $IFACE does not exit (cannot find /proc/sys/net/ipv4/conf/)"
exit 1
fi
echo 0 > /proc/sys/net/ipv4/conf/$IFACE/forwarding # IP forwarding disabled.
echo 1 >/proc/sys/net/ipv4/conf/$IFACE/log_martians # Log strange packets.
# (this includes spoofed packets, source routed packets, redirect packets)
# but be careful with this on heavy loaded web servers.
# Protección contra falsificación de IP (IP spoofing).
echo 1 > /proc/sys/net/ipv4/conf/$IFACE/rp_filter
# Disable ICMP redirect acceptance.
echo 0 > /proc/sys/net/ipv4/conf/$IFACE/accept_redirects
echo 0 > /proc/sys/net/ipv4/conf/$IFACE/send_redirects
# Desativa el ruteo en origen (source routing).
echo 0 > /proc/sys/net/ipv4/conf/$IFACE/accept_source_route
exit 0
An alternative solution is to create an init.d script and have it run on bootup (using update-rc.d to create the appropriate rc.d links).
4.18.4. Configuarción de las características de los cortafuegos
Para tener la capacidad del cortafuego, para proteger el sistema local u otros detrás de este, el kernel necesita estar compidalo con las capacidades del cortefuego. El Debian normal 2.2 kernel (también 2.2) susmistra el paquete de filtro del cortafuego ipchains, el kernel normal de Debian 3.0 (kernel 2.4) suministra el poderoso paquete de filtros de cortafuegos iptables (filtro de la red). Las distribucines más viejas de Debian necesitan el parche apropiado del kernel (Debian 2.1 usa el kernel 2.0.34).
En todo caso, es bastante fácil usar un kernel diferente al suministrado por Debian. Usted puede encontrar paquetes de kernel pre-compilados que puede instalar fácilmente en el sistemas de Debian. Usted tambiém puede obtener las fuentes del kernel usando kernel-source-X y armar paquetes de kernel personalizados con make-kpkg.
4.18.5. Disabling weak-end hosts issues
Systems with more than one interface on different networks can have services configured so that they will bind only to a given IP address. This usually prevents access to services when requested through any other address. However, this does not mean (although it is a common misconception) that the service is bound to a given
hardware address (interface card).
It seems, however, not to work with services bound to 127.0.0.1, you might need to write the tests using raw sockets.
This is not an ARP issue and it's not an RFC violation (it's called
weak end host in
RFC1122, (in the section 3.3.4.2). Remember, IP addresses have nothing to do with physical interfaces.
On 2.2 (and previous) kernels this can be fixed with:
# echo 1 > /proc/sys/net/ipv4/conf/all/hidden
# echo 1 > /proc/sys/net/ipv4/conf/eth0/hidden
# echo 1 > /proc/sys/net/ipv4/conf/eth1/hidden
.....
On later kernels this can be fixed either with:
Reglas Iptables
properly configured routing.
Along this text there will be many occasions in which it is shown how to configure some services (sshd server, apache, printer service...) in order to have them listening on any given address, the reader should take into account that, without the fixes given here, the fix would not prevent accesses from within the same (local) network.
FIXME: Comments on Bugtraq indicate there is a Linux specific method to bind to a given interface.
FIXME: Submit a bug against netbase so that the routing fix is standard behavior in Debian?
4.18.6. Protección contra ataques ARP
When you don't trust the other boxes on your LAN (which should always be the case, because it's the safest attitude) you should protect yourself from the various existing ARP attacks.
As you know the ARP protocol is used to link IP addresses to MAC addresses (see
ftp://ftp.isi.edu/in-notes/rfc826.txt for all the details). Every time you send a packet to an IP address an ARP resolution is done (first by looking into the local ARP cache then if the IP isn't present in the cache by broadcasting an ARP query) to find the target's hardware address. All the ARP attacks aim to fool your box into thinking that box B's IP address is associated to the intruder's box's MAC address; Then every packet that you want to send to the IP associated to box B will be send to the intruder's box...
Those attacks (ARP cache poisoning, ARP spoofing...) allow the attacker to sniff the traffic even on switched networks, to easily hijack connections, to disconnect any host from the network... ARP attacks are powerful and simple to implement, and several tools exists, such as
arpspoof from the
dsniff package or
http://arpoison.sourceforge.net/.
However, there is always a solution:
